Wallpaper Process Guide

Here is a step-by-step guide on our wallpapering process.

Step 1: measure the walls

Pick an area of the wall with no switches or sockets and measure the length. Add 20 centimetres for leeway and use the tape measure to mark the back of the paper where we need to cut. Fold wallpaper over on itself and cut the first strip. 

Step 2: mark the wall for guidance

Using the plumb line measuring tool, mark a vertical line on the wall near, right next to where the strip should go. We’ll use this line as a guide when hanging the first strip. 

Step 3: apply the wallpaper paste

Time for the application process. Use the brush to apply the wallpaper paste to the surface in even layers. Starting at the top and working our way down. Perch on the stepladder to reach the ceiling if you need to. 

Step 4: position the wallpaper

Once we’ve pasted the wall, position the wallpaper to check alignment. If it all looks straight, apply the first strip to the top and start to smooth it out from the centre to the edges using a clean cloth.

Step 5: trim and tidy

Trim off any excess wallpaper using the knife and ruler. Papering around switches and sockets? Cover them up with a wallpaper strip and use the knife to cut around them to avoid sloppy edges.

Step 6: smooth

Smooth the seams as we go for the best finish. Always smooth out from the centre of the strip to avoid air bubbles. 

Step 7: repeat!

Repeat this process for the entire wall.